Products Description
T nuts, commonly called tee nuts and blind nuts, are used in wood, composite, particle or other soft materials. Made from an internal threaded barrel and flange, t nuts have small prongs (usually 3 or 4) that dig into the soft installation surface. They can sometimes be serrated to provide a better grip. The prongs of a tee nut act as hooks to hold the nut to the surface leaving a flush face on the nut side, as long as the bolt is the right length.
Installing a T nut is pretty straightforward. First, grab a drill bit that's just a little wider than the barrel of the blind nut and use it to drill a hole in the soft material. Next, you can either push the nut in or give it a light tap with a hammer so the prongs start gripping into the material. Then, stick the bolt through from the other side and screw it into the T nut. Finally, tighten the bolt. As you tighten it, the nut will get pulled into the soft material until it's flat against the surface.
01.How do you install T nuts?
First, drill the hole for the bolt you want to fasten down. Then press the t-nut against one end of the hole while fastening the bolt down until it catches the t-nut's threading. Once the bolt catches the threading of the t-nut, continue to fasten the bolt down to pull the t-nut into the wood. After the t-nut is all the way in, you can freely remove the bolt and re-insert the bolt as needed, and the t-nut will stay installed into the wood.
02.How do you use T nuts?
T-nuts are used primarily for wood with machine threaded bolts. You use them by attaching the t-nut to one end of a predrilled hole and then fastening a bolt through the hole and nut. Fastening the bolt down causes the t-nut to bite into the wood and become flush with the wood's surface once fully installed. Once the t-nut is in place, this gives you the ability to use the t-nut to fasten machine threaded fasteners to the wood.
03.How do you remove T nuts?
T-nuts were not designed to be removed once installed. If they absolutely must be removed, you would need to pry them off. Be warned that this may damage the wood.
|
Material |
Carbon Steel / stainless steel/Zinc/Black/Customized |
|
Color |
Black / Blue / Yellow Zinc Plated / Plain |
|
Standard |
DIN,ASME,ASNI,ISO |
|
Finished |
Zinc Plated,Hot Dip Galvanized Steel,Dacromet,Nickel Plated,Black Oxide,Plain |
|
Mark |
According to customer's requirement |
|
Delivery time |
Normally in15-30 days. |
|
Package |
Cartons&pallets or according to customer's requirement. |
Company Introduction
FAQ
Q1: Are you trading company or manufacturer ?
A1: We are factory and manufacturer.
A2: For products in stock, we can ship it within 7 days after receiving your payment. For custom order, within 24 tons, production time is 20-35 days after confirmed every details.
A3: As we have more than thousands of products, it is really too hard to send all of catalogue and price list for you. Please inform us the style you interested, we can offer the pricelist for your reference.
A4:We are very confident in our products, and we pack them very well to make sure the goods in well protection.To avoid any subsequent trouble regarding quality issue, we suggest you check the goods once you receive them. If there is any transport damaged or quality issue, don't forget take the detail pictures and contact us as soon as possible, we will properly handle it to make sure your loss to reduce to the smallest.
Hot Tags: four claw tee nut, China, manufacturers, suppliers, factory, wholesale, customized, buy, motor connector block, din rail terminal blocks phoenix contact, 5 amp connector strip, relay holder block, power distribution terminal block, 20a terminal block